污水处理曝气鼓风机主要用于污水处理行业曝气鼓风机，有的行业也叫曝气鼓风机，主要是在鼓风机的出口接管道至污水处理池底部，进行曝气，使污水处理池中的生物活性物能充分与污水中的物质接触，从而达到除污的目的。

　　污水处理曝气鼓风机为离心式单吸入双支撑结构，由电机或汽轮机经弹性柱销联轴器驱动鼓风机传动。从电机或汽轮机后端看，鼓风机转子逆时针方向旋转，进、出风口朝上。鼓风机壳体由铸铁浇铸而成，具有减振、降噪、耐腐蚀、耐高温等优点。主轴用优质碳钢制成，叶轮由普通低合金钢制成，若压力过高的话一般采用高强度合金钢制成。轴承有滚动和滑动的，滚动轴承采用二硫化钼锂基润滑脂润滑，滑动轴承采用强制供油润滑。污水处理曝气鼓风机一般为多级，流量一般在20-500标米每分钟，压力一般在3500-20000mmH2O。污水处理多级离心式鼓风机在污水处理方面优于罗茨鼓风机,如噪声低,效率高,调节方便,不宜磨损,系统效率高,振动小,寿命长,性价比高,节能等等.以上资料由湖北风机厂的章秀坤提供。污水处理曝气鼓风机主要使用于:污水处理厂鼓风曝气,工业污水处理曝气,小型生活污水处理曝气,医院及实验室污水处理曝气.

　　污水处理曝气鼓风机主要有以下几种:

　　1.离心式鼓风机:噪声低,效率高,风量大,振动小.

　　2.罗茨鼓风机:噪音较大.压力高,风量大.

　　瑞柘生产销售的罗茨鼓风机便经常在污水处理曝气环境中使用，也有一些市政工程的水生态治理项目选用瑞柘沉水式罗茨鼓风机!具体的应用案例在我们的网站上有很多!您可以参考了解一下!

　　3.回转式鼓风机高效节能,噪音低,转速低,寿命长.

　　4.水环式鼓风机.静音,无油,环保.

　　5.磁悬浮鼓风机，清洁无污染噪音低节能环保

　　Sewage treatment aeration blowers are mainly used for aeration blowers in sewage treatment industry. Some industries are also called aeration blowers. The outlet of the blowers is connected to the bottom of the sewage treatment tank for aeration, so that the bioactive substances in the sewage treatment tank can fully contact with the substances in the sewage, so as to achieve the purpose of decontamination.

　　The sewage treatment aeration blower is a centrifugal single suction double support structure, which is driven by the motor or turbine through the elastic pin coupling. From the rear end of the motor or turbine, the blower rotor rotates counterclockwise, and the air inlet and outlet face upward. The blower shell is cast from cast iron, which has the advantages of vibration reduction, noise reduction, corrosion resistance and high temperature resistance. The main shaft is made of high-quality carbon steel, and the impeller is made of ordinary low-alloy steel. If the pressure is too high, it is generally made of high-strength alloy steel. There are rolling and sliding bearings. The rolling bearings are lubricated with molybdenum disulfide lithium base grease, and the sliding bearings are lubricated with forced oil supply. The aeration blower for sewage treatment is generally multi-stage, with a flow rate of 20-500 standard meters per minute and a pressure of 3500-20000mh2o. Multistage centrifugal blowers for sewage treatment are superior to roots blowers in sewage treatment, such as low noise, high efficiency, convenient adjustment, no wear, high system efficiency, low vibration, long service life, high cost performance, energy saving, etc The above information was provided by zhangxiukun of Hubei fan factory. The sewage treatment aeration blower is mainly used for: air blowing aeration in sewage treatment plant, industrial sewage treatment aeration, small domestic sewage treatment aeration, hospital and laboratory sewage treatment aeration

　　Sewage treatment aeration blowers mainly include the following types:

　　1. centrifugal blower: low noise, high efficiency, large air volume and small vibration

　　2. roots blower: noisy High pressure and large air volume

　　Roots blowers produced and sold by Ruizhe are often used in sewage treatment aeration environment. Ruizhe submerged roots blowers are also selected for water ecological treatment projects of some municipal projects! There are many specific application cases on our website! You can refer to it!

　　3. the rotary blower is energy efficient, low noise, low speed and long service life

　　4. water ring blower Quiet, oil-free, environmentally friendly

　　5. magnetic levitation blower, clean, pollution-free, low noise, energy saving and environmental protection